Dust Collection - Grizzly G0764Z Owner's Manual

Dust Collection

This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust collection system.
Minimum CFM at 5" Dust Port:
Minimum CFM at 4" Dust Port:
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
-38-
To connect dust collection hoses:
1.
615 CFM
400 CFM
Figure 64. 5" dust hose attached to dust port.
2.
Horizontal Arm
Figure 65. Dust hose attached to blade guard.
3.
Fit 5" dust hose over dust port on rear side of
cabinet, as shown in Figure 64, and secure
with hose clamp.
Connect 4" dust hose to end of horizontal
arm, then attach it to a single dust collection
branch line.
Tug on dust hoses to make sure they do not
come off. A tight fit is necessary for proper
performance.
Model G0764Z (Mfd. Since 10/15)
Hose Clamp
Dust
Hose