Inventory - Grizzly G0764Z Owner's Manual

Inventory

These are the "loose" components shipped with
the machine. Before setup, lay them out to make
sure you have everything listed below.
If any non-proprietary parts are missing (e.g. a
nut, bolt, or washer), we will gladly ship them upon
verification of order. For the sake of expediency,
you can also get replacement parts at your local
hardware store.
Inventory (Figure 10)
A. Small Extension Table ................................ 1
— Set Screws M10-1.5 x 20 ........................ 2
— Hex Nuts M10-1.5 ................................... 2
B. Large Extension Table ............................... 1
— Set Screws M10-1.5 x 20 ........................ 3
— Hex Nuts M10-1.5 ................................... 3
C. Crosscut Table ........................................... 1
D. Crosscut Fence .......................................... 1
E. Crosscut Table Brace ................................. 1
F.
Rip Fence Rail w/Fasteners ....................... 1
G. Rip Fence Scale ......................................... 1
H. Rip Fence ................................................... 1
I.
Cabinet Door .............................................. 1
A
C
I
Figure 10. G0764Z Inventory 1.
-20-
Qty
B
D
E
F
G
H
Inventory (Figure 11)
J. Rip Fence Body Assembly ......................... 1
K. Push Handle Assembly .............................. 1
— Push Handle ........................................... 1
— T-Nut M12-1.75 ........................................ 1
— Flat Washer 12mm .................................. 1
— Flat Washer 12mm (Copper) .................. 1
L. Crosscut Fence Flip Stops ......................... 2
M. Edge Shoe Assembly ................................. 1
N. Push Stick .................................................. 1
O. Riving Knife ................................................ 1
P.
Hold-Down Assembly ................................ 1
Q. Blade Guard Cover (Straight) ..................... 1
R. Blade Guard Connection Plate Assembly .. 1
S. Blade Guard Cover (Wide) ......................... 1
T.
Blade Guard Dust Hood ............................. 1
U. Dust Port Connection ................................. 1
V.
End Plate w/Handle (Sliding Table) ............ 1
W. Arm Support Base ...................................... 1
X. Arm Support Pedestal ................................ 1
Y.
Upper Support Arm .................................... 1
Z. End Cap (Sliding Table) .............................. 1
ZZ. Dust Hose ................................................... 1
J
K
N
Q
O
S
U
X
Y
Figure 11. G0764Z Inventory 2.
Model G0764Z (Mfd. Since 10/15)
Qty
L
M
P
R
T
W
V
ZZ
Z