Individual Settings; Laying The Cables - Dürkopp Adler 650-10 Service Instructions Manual

Individual settings

3
Always adhere to the specified sequence for the individual steps.
Always observe all information on requirements and following settings
marked at the side with

3.1 Laying the cables

Ensure that all cables in the machine are laid in such a way that they do
not impair the function of the moving parts.
To lay the cables:
1. Lay any cable that is too long neatly in proper cable snakes.
2. Tie the snakes together using a cable tie.
Service Instructions 650-10 - 01.0 - 08/2016
Individual settings
NOTICE
Property damage due to incorrect sequence!
Failure to observe can result in damage to the machine.
It is essential to adhere to the working sequence specified in this
manual.
WARNING
Risk of injury from moving parts, cutting and
sharp parts!
Crushing, cutting and puncturing are possible.
Switch off the main switch.
If possible, only change settings when the machine
is switched off.
NOTICE
Property damage and malfunctions due to laying the cables
incorrectly!
Excess cabling may obstruct moving machine parts in their ability to
function correctly. This affects the sewing process and can result in
damage to the machine.
Lay excess cable as described above.
If possible, bind the snakes to fixed parts.
.
13