Flats On Shafts - Dürkopp Adler 650-10 Service Instructions Manual

Inserting the throat plate
Fig. 6: Inserting the throat plate
①
②
(1) - Pins
(2) - Middle section holder
(3) - Guide piece
(4) - Screws
To insert the throat plate:
1. Insert the throat plate (7) from above.
2. Insert the guide piece (3) such that the pins (1) engage in the throat
3. Tighten the guide piece (3) using the screws (4).
4. Fit the material support and column cover ( p. 16).

3.4 Flats on shafts

Flats on shafts look like this:
Fig. 7: Flats on shafts
(1) - Flat
Some shafts have flat surfaces at the points where the components are
screwed on. This stabilizes the connection and makes adjustment easier.
Important
Always ensure that the screw faces are completely flush with the surface!
18
③
plate (7) and the middle section holder (2) fits into the recess (6) for
the hook (5).
(2) - Shaft
Individual settings
⑦
④
(5) - Hook
(6) - Recess
(7) - Throat plate
Service Instructions 650-10 - 01.0 - 08/2016
⑥
⑤