Removing And Inserting The Throat Plate - Dürkopp Adler 650-10 Service Instructions Manual

Individual settings
Removing the sewing material support and column cover
To remove the sewing material support and column cover:
1. Loosen both screws (1).
2. Lift the sewing material support (3) slightly and remove it to the left.
3. Lift the column cover (2) slightly and remove it to the left.
Fitting the sewing material support and column cover
To fit the sewing material support and column cover:
1. Fit the column cover (2) from the top left.
2. Fit the sewing material support (3) from the top left.
3. Tighten both screws (1).

3.3.5 Removing and inserting the throat plate

Removing the throat plate
Fig. 5: Removing the throat plate
①
②
(1) - Pins
(2) - Middle section holder
(3) - Guide piece
(4) - Screws
To remove the throat plate:
1. Remove the material support and column cover ( p. 16).
2. Loosen the screws (4).
3. Remove the guide piece (3).
4. Remove the throat plate (7) upwards.
Service Instructions 650-10 - 01.0 - 08/2016
⑦
③ ④
(5) - Hook
(6) - Recess
(7) - Throat plate
⑥
⑤
17