Dürkopp Adler 650-10 Service Instructions Manual page 71

Service settings via software (OP3000)
To perform the automatic input test:
1. Actuate the element as described in the Action column (see table
 In
Test Sew. Motor
In the submenu Test Sew. Motor, you can test the sewing motor.
Fig. 60: Test Sew. Motor
To test the sewing motor:
1. Press the OK key.
 The machine performs a reference run.
2. In
3. Press the OK key.
 The motor runs at the entered speed.
4. Press ESC key to end.
Test Step Motor
In the submenu Test Step Motor, you can test the stepper motors for
sewing feet and conveyor belts.
Fig. 61: Test Step Motor
To test the stepper motor:
1. Use
2. Press the OK key.
3. Use
 If the motor is functioning correctly, the behavior described in the
Service Instructions 650-10 - 01.0 - 08/2016
above).
, the display shows the number of the element last
Input
changed.
If the element is functional, the display switches between
OFF under Value .
M
/
, use to enter a speed in steps of 50.
Speed
M
/ in the
Stepper
/
to test the respective motor.
table will be shown.
350
2
field to choose the motor that you wish to test.
and
ON
69