Dürkopp Adler 650-10 Service Instructions Manual page 51

Individual settings
Fitting the thread tensioning spring
Fig. 38: Fitting the thread tensioning spring
(1) - Setscrew
(2) - Inner cylinder
(3) - Tension disks
(4) - Release pin
To fit the thread tensioning spring:
1. Pull the loose end of the thread tensioning spring (7) through the
2. Insert the thread tensioning spring (7) into the cylinder.
3. Insert the tensioning bolt with the tension disks in the cylinder (3), and
4. Tighten the setscrew on the cylinder (5).
5. Insert the inner cylinder (2) in the housing of the thread tensioner.
6. Tighten the setscrew (1).
7. Insert the thread tensioner ( p. 45).
Important
Leave the tension disks on the tension bolt!
If the tension disks have been removed, recalibrate the thread tension
using the software:
• OP3000 ( p. 70)
• OP7000 ( p. 93)
Service Instructions 650-10 - 01.0 - 08/2016
slot (6).
put the groove on the hook (8) of the thread tensioning spring.
Important
The release pin (4) must be at the bottom of the cylinder!
(5) - Setscrew on cylinder
(6) - Slot
(7) - Thread tensioning spring
(8) - Hook
49