Dürkopp Adler 650-10 Service Instructions Manual page 49

Individual settings
Fitting the thread tensioner
Fig. 36: Fitting the electrical thread tensioner
(1) - Thread tensioner
(2) - Access hole in
To fit the electric thread tensioner:
1. Feed the cable of the thread tensioner (1) through the opening in the
2. Insert the thread tensioner (1).
3. Insert the cable shoe (4) into the transparent plug (3).
4. Lay cables that are too long in loops such that moving machine parts
5. Tie the cable loops together using a cable tie.
6. Tighten the setscrew through the access hole (2).
Information
If you receive a new thread tensioner as a spare part from Dürkopp Adler,
this will already be pre-calibrated. The adjusting screw for the spring ten-
sion is sealed.
You only need to enter the values for calibration positions 2 and 1 as indi-
cated on the sticker on the machine head using the software:
• OP3000 ( p. 70)
• OP7000 ( p. 93).
Set the thread tension for thread cutting using the software:
• OP3000 ( p. 62)
• OP7000 ( p. 87)
Service Instructions 650-10 - 01.0 - 08/2016
the housing face side
machine arm and backwards towards the transparent plug (3).
are not impaired in their ability to function correctly.
(3) - Plugs
(4) - Cable shoe
47