Replacing And Setting The Bottom Conveyor Belts; Replacing The Bottom Conveyor Belts - Dürkopp Adler 650-10 Service Instructions Manual

Individual settings
Setting the distance from the jump protection
To set the distance from the jump protection:
1. Loosen both screws (5) on the jump protection (4).
2. Push the jump protection (4) upwards or downwards until there is a
3. Tighten both screws (5) on the jump protection (4).

3.17 Replacing and setting the bottom conveyor belts

3.17.1 Replacing the bottom conveyor belts

Cover
• Tilt the machine head ( p. 14)
• Remove the material support and column cover ( p. 16)
• Removing the throat plate ( p. 17)
Fig. 29: Dismounting the bottom conveyor belts
(1) - Gear rims
(2) - Bottom conveyor belts
(3) - Base plate cutout
Dismounting the bottom conveyor belts
To dismount the bottom conveyor belts:
1. Use the handwheel to position the needle in the top dead center.
2. Remove both conveyor belts (2) from the bottom gear wheel (5).
3. Pull the conveyor belts (2) upwards through the base plate cutout (3).
4. Remove both conveyor belts from the gear rims on the throat plate (1)
Service Instructions 650-10 - 01.0 - 08/2016
distance of 0.2 – 0.3 mm from the top right conveyor belt (3).
one after the other.
(4) - Screws
(5) - Lower gear wheel
(6) - Mounting bracket
39