Dürkopp Adler 650-10 Service Instructions Manual page 126

Code Type
2481 Error
2482 Error
2483 Error
2484 Error
2485 Error
2486 Error
2487 Error
2488 Error
2901 Error
3010 Error
3011 Error
3012 Error
3020 Error
3021 Error
3022 Error
3030 Error
124
Possible causes
Error in the reference run
Stepper motor current error
Stepper motor overcurrent
Software error
Stepper motor insulation error
Software error
Software error
Software error
Referencing timeout
Controller: 100 V voltage error
Controller: 100 V voltage error
Controller: 100 V voltage error (I²T) • Switch the machine off and on
Short circuit in 24 V input or output • Check the connections
Short circuit in 24 V input or output • Check the connections
Short circuit in 24 V input or output
(I²T)
Sewing motor phase error
Troubleshooting
Remedial action
• Replace the reference switch
• Remove the blockage
• Check the encoder cable and
replace, if necessary
• Replace the stepper motor
• Replace the sewing motor cable
• Replace the stepper motor
• Replace the control
• Perform reset
• Perform a software update
• Contact customer service
• Check motor phase and PE for
low-impedance connection
• Replace the encoder
• Replace the stepper motor
• Perform reset
• Perform a software update
• Contact customer service
• Perform reset
• Perform a software update
• Contact customer service
• Perform reset
• Perform a software update
• Contact customer service
• Switch the machine off and on
again
• Check the clamping of the stepper
motor
• Check the connections
• Replace the control
• Check the connections
• Replace the control
again
• Check the connections
• Replace the control
• Replace the control
• Replace the control
• Switch the machine off and on again
• Check the connections
• Replace the control
• Test sewing motor phases
(R = 2,8 Ω, high impedance to PE)
• Replace the encoder
• Replace the sewing motor
• Replace the control
Service Instructions 650-10 - 01.0 - 08/2016