Dürkopp Adler 650-10 Service Instructions Manual page 117

Troubleshooting
Code Type
1010 Error
1011 Error
1012 Error
1051 Error
1052 Error
1053 Error
1054 Error
1055 Error
1056 Error
1058 Error
1060 Error
1061 Error
1062 Error
1120 Error
Service Instructions 650-10 - 01.0 - 08/2016
Possible causes
Sewing motor synchronization
error:
• External synchronizer plug
(Sub-D, 9-pin) not connected
Sewing motor synchronization error
(Z pulse)
Sewing motor synchronization error • Replace the synchronizer
Sewing motor timeout:
• Cable to sewing motor reference
switch defective
• Reference switch defective
Sewing motor overcurrent:
• Sewing motor cable defective
• Sewing motor defective
• Controller defective
Sewing motor overvoltage
Internal short circuit
Sewing motor overload (I²T):
• Sewing motor not moving freely
or blocked
• Sewing motor defective
• Controller defective
Sewing motor overtemperature:
• Sewing motor not moving freely
• Sewing motor defective
• Controller defective
Sewing motor speed greater than
setpoint:
• Reference switch defective
• Sewing motor defective
PowerParts
Sewing motor fault:
• Encoder defective
• Sewing motor defective
Sewing motor fault
(IDMA auto increment)
Software error:
• Parameter not initialized
Remedial action
• Connect plug of external synchro-
nizer to controller, use correct con-
nection (Sync)
• Replace the reference switch or
synchronizer
• Only required for machines with
transmission!
• Switch off the controller, use hand-
wheel to turn and switch on the
controller again
• If error is not corrected, check
encoder
• Replace the cable
• Replace the reference switch
• Replace the sewing motor cable
• Replace the sewing motor
• Replace the control
• Check the mains voltage
• Replace the control
• Remove the cause of the stiff
movement or blockage
• Replace the sewing motor
• Replace the control
• Correct the cause of not moving
freely
• Replace the sewing motor
• Replace the control
• Replace the reference switch
• Replace the sewing motor
• Replace the control
• Switch the machine off and on
again
• Replace the encoder
• Replace the sewing motor
• Contact customer service
• Switch the machine off and on
again
• Perform a software update
115