Table of Contents
Advertisement
Figure 57. Drive cage screws removal
Step 5.
Remove the drive cage out of the water-cooled technology tray.
If you are instructed to return the server component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Replacing the optional drive cage
Use this information to install the optional drive cage.
Read the safety information in Safety and Installation guidelines.
Note: You only need to install a drive cage if it was previously removed for system board Service.
To install the optional drive cages, complete the following steps:
Step 1.
Turn off the water-cooled technology tray and peripheral devices and disconnect the power cords
and all external cables.
Step 2.
Remove the cover (see "Removing the cover" on page 142).
Step 3.
If this is the first time that you install the drive cage, remove the one torx head screw from the
water-cooled technology tray.
150
Lenovo NeXtScale nx360 M5 water-cooled technology tray Lenovo NeXtScale n1200 Enclosure Installation and Service Guide
Drive cages
Advertisement
Table of Contents
Troubleshooting
