Diagnostic Text Messages - Lenovo NeXtScale nx360 M5 Installation And Service Manual

Note: The DSA Preboot diagnostic program might appear to be unresponsive for an unusual length
of time when you start the program. This is normal operation while the program loads. The loading
process may take up to 10 minutes.
Step 4. Optionally, select Quit to DSA to exit from the stand-alone memory diagnostic program.
Note: After you exit from the stand-alone memory diagnostic environment, you must restart the
server to access the stand-alone memory diagnostic environment again.
Step 5. Type gui to display the graphical user interface, or type cmd to display the DSA interactive menu.
Step 6. Follow the instructions on the screen to select the diagnostic test to run.
If the diagnostic programs do not detect any hardware errors but the problem remains during normal server
operation, a software error might be the cause. If you suspect a software problem, see the information that
comes with your software.
A single problem might cause more than one error message. When this happens, correct the cause of the
first error message. The other error messages usually will not occur the next time you run the diagnostic
programs.
If the server stops during testing and you cannot continue, restart the server and try running the DSA Preboot
diagnostic programs again. If the problem remains, replace the component that was being tested when the
server stopped.

Diagnostic text messages

Diagnostic text messages are displayed while the tests are running.
A diagnostic text message contains one of the following results:
Passed: The test was completed without any errors.
Failed: The test detected an error.
Aborted: The test could not proceed because of the server configuration
Additional information concerning test failures is available in the extended diagnostic results for each test.
Viewing the test log results and transferring the DSA collection
Use this information to view the test log results and transferring the DSA collection.
To view the test log for the results when the tests are completed, click the Success link in the Status column,
if you are running the DSA graphical user interface, or type :x to exit the Execute Tests menu, if you are
running the DSA interactive menu, or select Diagnostic Event Log in the graphical user interface. To transfer
DSA Preboot collections to an external USB device, type the copy command in the DSA interactive menu.
Step 1. If you are running the DSA graphical user interface (GUI), click the Success link in the Status
column.
If you are running the DSA interactive menu (CLI), type :x to exit the Execute Tests menu; then,
Step 2.
select completed tests to view the results.
You can also send the DSA error log to Lenovo support to aid in diagnosing the server problems.
66
Lenovo NeXtScale nx360 M5 water-cooled technology tray Lenovo NeXtScale n1200 Enclosure Installation and Service Guide