Nextscale Nx360 M5 Water-Cooled - Lenovo NeXtScale nx360 M5 Installation And Service Manual

Figure 121. Installation of a chassis midplane into a chassis
Attention:
• You must hold the chassis midplane up against the top inside of the chassis shell and keep the
chassis midplane vertical during installation. If the chassis midplane is not inserted correctly, the
guide pins can contact the chassis midplane connectors and damage the connector pins.
• Do not grasp the connectors on the chassis midplane when you install it in the chassis. Touching
the connectors might damage the connector pins.
• Make sure that the fan and power controller cable is out of the way when you slide the chassis
midplane into the chassis.
Step 3. Connect the two cables back to fan power connectors and fan signal connectors back to the
chassis midplane.
Step 4. Slide the chassis midplane all the way into the chassis until it stops.
Step 5. Tighten the three captive screws that secure the chassis midplane to the chassis.
Step 6. Rotate the top cover inwards.
Step 7. Tighten the three captive screws on the top cover.
196
Lenovo NeXtScale nx360 M5 water-cooled technology tray Lenovo NeXtScale n1200 Enclosure Installation and Service Guide