Dsa Checkpoint Panel Test Results; Test Results For The Dsa Checkpoint Panel Test - Lenovo NeXtScale nx360 M5 Installation And Service Manual

4. If the problem remains, contact your IBM technical-support representative.
Related links
– Lenovo Support website
– Latest level of DSA

DSA checkpoint panel test results

The following messages can result when you run the checkpoint panel test.

Test results for the DSA checkpoint panel test

The following messages can result when you run the DSA checkpoint panel test.
• 180-000-000 : Check-point Panel Test Passed
Check-point Panel Test Passed.
Recoverable
No
Severity
Event
Serviceable
No
Automatically notify support
No
Related links
– Lenovo Support website
– Latest level of DSA
• 180-801-000 : Check-point Panel Test Aborted
Check-point Panel Test Aborted. BMC is unable to verify that the operator information panel cable is
connected.
Recoverable
No
Severity
Warning
Serviceable
Yes
Automatically notify support
No
User Response
Complete the following steps:
1. Inspect and reseat operator information panel cable at both ends.
2. Verify that the Baseboard Management Controller (BMC) is working.
3. Run the test again.
4. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service
Guide" for the next corrective action.
Related links
– Lenovo Support website
Appendix C. DSA diagnostic test results
731