Figure 9. Chassis and manifold components
Blue on a component indicates touch points, where you can grip the component to remove it from or install it
in the server, open or close a latch, and so on.
Orange on a component or an orange label on or near a component indicates that the component can be
hot-swapped, which means that if the server and operating system support hot-swap capability, you can
remove or install the component while the server is running.
Note: Orange can also indicate touch points on hot-swap components.
See the instructions for removing or installing a specific hot-swap component for any additional procedures
that you might have to perform before you remove or install the component.
System-board internal connectors
The following illustration shows the internal connectors on the system board.
24
Lenovo NeXtScale nx360 M5 water-cooled technology tray Lenovo NeXtScale n1200 Enclosure Installation and Service Guide
Fan filler
Drip sensor
Fan and power
controller (FPC)
Manifold assembly
Chassis
Power supply