Nextscale Nx360 M5 Water-Cooled - Lenovo NeXtScale nx360 M5 Installation And Service Manual

Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with one
of these parts, contact a service technician.
Read the safety information in Safety and Installation guidelines.
To replace or install a hot-swap power supply, complete the following steps.
Step 1. Slide the hot-swap power supply into the bay until the release latch clicks into place.
Important: During normal operation, each power-supply bay must contain either a power supply or
power-supply filler panel for proper cooling.
Figure 76. Hot-swap power supply installation
Step 2. Connect one end of the power cord for the new power supply into the ac connector on the back of
the power supply; then, connect the other end of the power cord into a properly grounded electrical
outlet.
Step 3. If the server is turned off, turn on the server.
164
Lenovo NeXtScale nx360 M5 water-cooled technology tray Lenovo NeXtScale n1200 Enclosure Installation and Service Guide
Power supply