Dsa Tape Drive Test Results; Test Results For The Dsa Tape Drive Test - Lenovo NeXtScale nx360 M5 Installation And Service Manual

Water-cooled technology tray; enclosure
Hide thumbs Also See for NeXtScale nx360 M5:
Table of Contents

Advertisement

IMM Indicates failure in PSOC – On Board PSOC IC I2C Switch bus (BUS 4).
Recoverable
No
Severity
Error
Serviceable
Yes
Automatically notify support
No
User Response
Perform the actions mentioned one at a time and try the test after each action:
1. Turn off the system and disconnect it from power. Wait for 45 seconds. Reconnect it to power.
2. Make sure that DSA and BMC/IMM are at the latest level.
3. Run the test again.
4. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service
Guide" for the next corrective action.
Related links
– Lenovo Support website
– Latest level of DSA

DSA tape drive test results

The following messages can result when you run the tape drive test.

Test results for the DSA tape drive test

The following messages can result when you run the DSA tape drive test.
• 264-000-000 : Tape Test Passed
Tape Test Passed.
Recoverable
No
Severity
Event
Serviceable
No
Automatically notify support
No
Related links
– Lenovo Support website
– Latest level of DSA
• 264-901-000 : Tape Test Failed
An error was found in the tape alert log.
Recoverable
No
Appendix C. DSA diagnostic test results
839

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nextscale n1200

Table of Contents