Water Loop Replacement; Only) - Lenovo ThinkSystem SD650 V3 User Manual

Procedure
Step 1. Install the front and the rear cross braces (14x Phillips #1 screws).
Figure 20. Cross brace installation (SD650 V3)
After you finish
1. Install the tray cover. See
2. Install the tray into the enclosure. See
3. Connect all required external cables to the solution.
Note: Use extra force to connect QSFP cables to the solution.
4. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all
nodes are ready to be powered on.
Water loop replacement (trained technician only)
Use the following procedures to remove and install the water loop in the SD650 V3 tray.
ThinkSystem SD650 V3 Neptune DWC Tray User Guide
48
"Install the tray cover" on page
"Install a DWC tray in the enclosure" on page
44.
42.