Table of Contents
Advertisement
Manifold retention bracket
Figure 47. Retention bracket installation
Removing a water-cooled technology tray from a chassis
Use this information to remove a water-cooled technology tray from a Lenovo NeXtScale n1200 Enclosure
Type 5468.
Before you remove a water-cooled technology tray, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 28.
2. If the water-cooled technology tray is operating, shut down the operating system.
3. Press the power button to turn off both systems in the water-cooled technology tray (see "Turning off
the server" on page 19 for more information).
To remove the water-cooled technology tray from a chassis, complete the following steps:
Step 1.
Open the front handles as shown in the illustration. The water-cooled technology tray moves out of
the tray bay approximately 0.6 cm (0.25 inch).
.
Chapter 6
Removing and replacing server components
139
Advertisement
Table of Contents
Troubleshooting
