Icom RS-BA1 Installation Manual page 16

Installtion guide B
1. Step2. 3. 4. 5.
Step2. Before configuration
To configure the remote control system, the following settings are required.
D Firewall setting (RS-BA1 Instruction Manual p. 1)
To let the Remote Utility work properly, it must be added as an exception in the Firewall. See the RS-BA1
Instruction Manual for details.
D To allow access from the Internet (RS-BA1 Instruction Manual p. 12)
If you configure the remote control system through the Internet, you need to configure the Base station and
Remote station routers to allow Internet access.
Configure the port forwarding settings and IP filter settings on your router for port numbers 50001, 50002, and
50003 which are used for the Remote Utility.
See your router's manual for details of how to configure the settings.
D Volume adjustment for your audio devices (RS-BA1 Instruction Manual p. 6)
Before you start communicating using the RS-BA1, the PC's audio volume must be set to a proper level.
Adjust the audio level of the device that your microphone, speaker, or headset is connected to.
If you connect the microphone, speaker, or headset after setting the audio level, confirm the level has not
changed.
See the RS-BA1 Instruction Manual ("1. BEFORE USING REMOTE CONTROL SYSTEM" section) for details.
B-3