Ipv6 Import-Route - HP 5920 Series Command Reference Manual

Usage guidelines
This command filters received routes. Only routes that have not been filtered can be added into the
routing table.
To reference an advanced ACL (with a number from 3000 to 3999) in the command or in the routing
policy, configure the ACL using one of the following methods:
To deny/permit a route with the specified destination, use the rule [ rule-id ] { deny | permit } ipv6
•
source sour sour-prefix command
To deny/permit a route with the specified destination and prefix, use the rule [ rule-id ] { deny |
•
permit } ipv6 source sour sour-prefix destination dest dest-prefix command.
The source keyword specifies the destination address of a route and the destination keyword specifies the
prefix of the route. The specified prefix must be valid. Otherwise, the configuration does not take effect.
Examples
# Use IPv6 ACL 2003 to filter received routes.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] ipv6 filter-policy 2003 import
# Configure IPv6 ACL 3000 to permit only route 2001::1/128 to pass. Use the ACL to filter received
routes.
<Sysname> system-view
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] rule 10 permit ipv6 source 2001::1 128 destination
ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff 128
[Sysname-acl6-adv-3000] rule 100 deny ipv6
[Sysname-acl6-adv-3000] quit
[Sysname] isis 1
[Sysname-isis-1] ipv6 filter-policy 3000 import
Related commands
ipv6 filter-policy export

ipv6 import-route

Use ipv6 import-route to enable IPv6 IS-IS to redistribute routes from another routing protocol.
Use undo ipv6 import-route to disable route redistribution.
Syntax
ipv6 import-route protocol [ process-id ] [ allow-ibgp ] [ cost cost | [ level-1 | level-1-2 | level-2 ] |
route-policy route-policy-name| tag tag ] *
undo ipv6 import-route protocol [ process-id ]
Default
IPv6 does not redistribute routes from any other routing protocol.
Views
IS-IS view
533