Rip Default-Route; Rip Enable - HP 5920 Series Command Reference Manual

[Sysname-Vlan-interface10] rip bfd enable destination 202.38.165.1

rip default-route

Use rip default-route to configure a RIP interface to advertise a default route with a specified metric.
Use undo rip default-route to disable a RIP interface from sending a default route.
Syntax
rip default-route { { only | originate } [ cost cost ] | no-originate }
undo rip default-route
Default
A RIP interface advertises a default route if the RIP process that the interface runs is enabled to advertise
a default route.
Views
Interface view
Predefined user roles
network-admin
Parameters
only: Advertises only a default route.
originate: Advertises both a default route and other routes.
cost: Specifies a cost for the default route, in the range of 1 to 15. The default is 1.
no-originate: Advertises only non-default routes.
Usage guidelines
An interface that is enabled to advertise a default route does not receive any default route from RIP
neighbors.
Examples
# Configure VLAN-interface 10 to advertise only a default route with a metric of 2.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip default-route only cost 2
# Configure VLAN-interface 10 to advertise a default route with a metric of 2 and other routes.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip default-route originate cost 2
Related commands
default-route

rip enable

Use rip enable to enable RIP on an interface.
Use undo rip enable to disable RIP on an interface.
75