Default Tag - HP 5920 Series Command Reference Manual

Parameters
value: Specifies the bandwidth reference value for link cost calculation, in the range of 1 to 2147483648
Mbps.
Usage guidelines
You can configure an OSPFv3 cost for an interface with one of the following methods:
• Configure the cost value in interface view.
Configure a bandwidth reference value. OSPFv3 computes the cost automatically based on the
•
bandwidth reference value by using the following formula: Interface OSPFv3 cost = Bandwidth
reference value / Interface bandwidth.
If the calculated cost is greater than 65535, the value of 65535 is used.
If the calculated cost is smaller than 1, the value of 1 is used.
If no cost value is configured for an interface, OSPFv3 computes the interface cost value automatically.
Examples
# Specify the reference bandwidth value as 1000 Mbps.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] bandwidth-reference 1000

default tag

Use default tag to configure a tag for redistributed routes.
Use undo default tag to restore the default.
NOTE:
This command is available in Release 2311P04 and later versions.
Syntax
default tag tag
undo default tag
Default
The tag of redistributed routes is 1.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
tag: Specifies a tag for redistributed routes, in the range of 0 to 4294967295.
Usage guidelines
If you do not specify a tag for redistributed routes by using the default-route-advertise, import-route, or
route-tag command, the tag specified by the default tag command applies.
442