Apply Cost - HP 5920 Series Command Reference Manual

Parameters
none: Removes the COMMUNITY attributes of BGP routes.
community-number&<1-32>: Specifies a community sequence number in the range of 1 to 4294967295.
&<1-32> indicates that the argument before it can be entered up to 32 times.
aa:nn&<1-32>: Specifies a community number; both aa and nn are in the range of 0 to 65535. &<1-32>
indicates that the argument before it can be entered up to 32 times.
internet: Sets the INTERNET community attribute for BGP routes. Routes with this attribute can be
advertised to all BGP peers. By default, all routes have this attribute.
no-advertise: Sets the NO_ADVERTISE community attribute for BGP routes. Routes with this attribute
cannot be advertised to any peers.
no-export: Sets the NO_EXPORT community attribute for BGP routes. Routes with this attribute cannot be
advertised out of the AS or confederation, but can be advertised to other sub-ASs in the confederation.
no-export-subconfed: Sets the NO_EXPORT_SUBCONFED community attribute for BGP routes. Routes
with this attribute cannot be advertised out of the local AS or to other sub-ASs in the confederation.
additive: Adds the specified COMMUNITY attribute to the original COMMUNITY attribute of BGP
routes.
Examples
# Configure node 16 in permit mode for routing policy setcommunity to set the NO_EXPORT community
attribute for BGP routes.
<Sysname> system-view
[Sysname] route-policy setcommunity permit node 16
[Sysname-route-policy-setcommunity-16] apply community no-export
Related commands
if-match community
•
ip community-list
•

apply cost

Use apply cost to set a cost for routes.
Use undo apply cost to restore the default.
Syntax
apply cost [ + | - ] value
undo apply cost
Default
No cost is set for routes.
Views
Routing policy node view
Predefined user roles
network-admin
553