If-Match Acl - HP 5920 Series Command Reference Manual

Views
Any view
Predefined user roles
network-admin
network-operator
Examples
# Display PBR configuration.
<Sysname> display ip policy-based-route setup
Policy Name
pr01
Table 96 Command output
Field
Interface Name
Related commands
ip policy-based-route

if-match acl

Use if-match acl to configure an ACL match criterion.
Use undo if-match acl to remove the ACL match criterion.
Syntax
if-match acl { acl-number | name acl-name }
undo if-match acl
Default
No ACL match criterion is configured.
Views
Policy node view
Predefined user roles
network-admin
Parameters
acl-number: Specifies an ACL by its number in the range of 2000 to 2999 for a basic ACL, and in the
range of 3000 to 3999 for an advanced ACL.
name acl-name: Specifies an ACL by its name, a case-insensitive string of 1 to 63 characters starting with
letter a to z or A to Z. The ACL name cannot be all.
Examples
# Configure Node 1 1 of policy aa to permit the packets matching ACL 201 1.
<Sysname> system-view
[Sysname] policy-based-route aa permit node 11
Interface Name
Vlan-interface 1
Description
Interface where the policy is applied.
407