Ospfv3 Timer Hello; Ospfv3 Timer Poll - HP 5920 Series Command Reference Manual

ospfv3 timer hello

Use ospfv3 timer hello to configure the hello interval for an interface.
Use undo ospfv3 timer hello to restore the default.
Syntax
ospfv3 timer hello seconds [ instance instance-id ]
undo ospfv3 timer hello [ instance instance-id ]
Default
The hello interval is 10 seconds for P2P and broadcast interfaces, and is 30 seconds for P2MP or NBMA
interfaces.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the hello interval in the range of 1 to 65535 seconds.
instance-id: Specifies an instance by its ID in the range of 0 to 255. The default is 0.
Usage guidelines
The shorter the hello interval is, the faster the topology converges and the more resources are consumed.
Make sure the hello interval on two neighboring interfaces is the same.
Examples
# Configure the hello interval as 20 seconds for VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer hello 20
Related commands
ospfv3 timer dead

ospfv3 timer poll

Use ospfv3 timer poll to set the poll interval on an NBMA interface.
Use undo ospfv3 timer poll to restore the default.
Syntax
ospfv3 timer poll seconds [ instance instance-id ]
undo ospfv3 timer poll [ instance instance-id ]
Default
The poll interval is 120 seconds on an interface.
Views
Interface view
505