Peer; Pic - HP 5920 Series Command Reference Manual

peer

Use peer to specify a neighbor in an NBMA or P2MP network.
Use undo peer to remove the configuration.
Syntax
peer ip-address [ cost value | dr-priority dr-priority ]
undo peer ip-address
Default
No neighbor is specified.
Views
OSPF view
Predefined user roles
network-admin
Parameters
ip-address: Specifies a neighbor by its IP address.
cost value: Specifies the cost to reach the neighbor, in the range of 1 to 65535.
dr-priority dr-priority: Specifies the DR priority for the neighbor, in the range of 0 to 255. The default
neighbor DR priority is 1.
Usage guidelines
In an NBMA or P2MP network, OSPF packets are sent in unicast, so you must use this command to
specify neighbors.
The cost set with the peer command applies only to P2MP neighbors. If no cost is specified, the cost to
the neighbor equals the local interface's cost.
A router uses the priority set with the peer command to determine whether to send a hello packet to the
neighbor rather than for DR election. The DR priority set with the ospf dr-priority command is used for DR
election.
Examples
# Specify the neighbor 1.1.1.1.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] peer 1.1.1.1
Related commands
ospf dr-priority

pic

Use pic to enable OSPF PIC.
Use undo pic to disable OSPF PIC.
168