Rip Input - HP 5920 Series Command Reference Manual

Syntax
rip process-id enable [ exclude-subip ]
undo rip enable
Default
RIP is disabled on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
process-id: Specifies a RIP process by its ID in the range of 1 to 65535.
exclude-subip: Excludes secondary IP addresses from being enabled with RIP. Without this keyword, RIP
is also enabled on secondary IP addresses of a RIP-enabled interface.
Usage guidelines
The rip enable command has a higher priority than the network command.
Examples
# Enable RIP process 100 on VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip 100 enable
Related commands
network

rip input

Use rip input to enable an interface to receive RIP messages.
Use undo rip input to disable an interface from receiving RIP messages.
Syntax
rip input
undo rip input
Default
An interface is enabled to receive RIP messages.
Views
Interface view
Predefined user roles
network-admin
Examples
# Disable VLAN-interface 10 from receiving RIP messages.
76