Create New Fxs Extension; Table 20: Fxs Extension Configuration Parameters - Grandstream Networks UCM6510 IP PBX User Manual

Other Settings
SRTP
Fax Detection
Strategy
Skip Trunk Auth
Codec Preference

CREATE NEW FXS EXTENSION

To manually create new FXS user, go to web GUI->PBX->Basic/Call Routes->Extensions. Click on
"Create New User"->"Create New FXS Extension" and a new dialog window will show for users to fill in
the extension information. The configuration parameters are as follows.
General
Extension
Firmware Version 1.0.0.25
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Enable SRTP for the call. The default setting is disabled.
Enable to detect Fax signal from the user/trunk during the call and send
the received Fax to the Email address configured for this extension. If no
Email address can be found for the user, send the received Fax to the
default Email address in Fax setting page under web GUI->PBX-
>Internal Options->Fax/T.38.
Note:
If enabled, Fax Pass-through cannot be used.
This option controls how the extension can be used on devices within
different types of network.

Allow All
Device in any network can register this extension.

Local Subnet Only
Only the user in specific subnet can register this extension. Up to
three subnet addresses can be specified.

A Specific IP Address
Only the device on the specific IP address can register this extension.
The default setting is "Allow All".
If enabled, users will not need enter the "PIN Set" required by the
outbound rule to make outbound calls. The default setting is "No".
Select audio and video codec for the extension. The available codecs are:
PCMU, PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723, ILBC,
ADPCM, H.264, H.263 and H.263p. In the selected codec list, users can
click on UP or DOWN arrow to adjust the order for the codec priority.

Table 20: FXS Extension Configuration Parameters

The extension number associated with the user.
UCM6510 IP PBX User Manual Page 69 of 229