Mitsubishi Q170MCPU User Manual page 79

2 SYSTEM CONFIGURATION
Do not short a battery.
Do not charge a battery.
Do not disassemble a battery.
Do not burn a battery.
Do not overheat a battery.
Do not solder the battery terminal.
The data (Refer to Section 6.5.) of RAM built-in Motion controller are backed up without using
the battery.
(3) Connection procedure with Motion controller
Set the battery (Q6BAT/Q7BAT) to the battery holder, and connect between the
lead connector of battery and connector of Motion controller.
Put the lead wire in the battery holder, and set it to the Motion controller.
Refer to Section 4.1.4 for the mounting and removal of the battery holder and the
connection of the battery lead wire.
CAUTION
Motion controller
2 - 52
PROGRAMMABLE CONTROLLER
PUSH
Q6BAT
TYPE
Battery holder