Mitsubishi Q170MCPU User Manual page 56

2 SYSTEM CONFIGURATION
24V(+) pin is upper side and 24G pin is lower side of 24VDC power supply connector (from front
view) of Motion controller. If the polarity is wrong, the unit may be damaged.
Recommend the use of twisted pair cabling for 24VDC power line
Power off the Motion controller before wiring 24VDC power supply.
Use proper size wire for 24VDC power line.
(9) 24VDC power supply connector
(a) The pin layout of the 24VDC power supply connector
24VDC power supply is supplied from the 24VDC power supply connector of
the front face of the Motion controller.
The pins layout (from front view) and connection of the 24VDC power supply
connector is shown below.
1A
2A
• Applicable connector model name
24VDC power supply connector set (Q170MPWCON) (Attachment)
1-1827864-2 connector (Tyco Electronics AMP K.K. make)
1827587-2 terminal
• Crimping tool
Tool type
Maker name : Tyco Electronics AMP K.K.
• Conductor size for power line
0.34 to 0.37mm
PIN No.
1B
(Note)
1A
(Note)
2A
(Note): Use "1A" and "2A" when the 24VDC voltage is applied
on EMI terminal and the forced stop input of EMI
2B
terminal is invalidated.
: 1762846-1
2
CAUTION
2 - 29
Signal name PIN No.
24V(+) 1B
24G 2B
Signal name
24V(+)
24G