Mitsubishi Q170MCPU User Manual page 34

2 SYSTEM CONFIGURATION
(15) Be sure to use the cable for forced stop input. The forced stop cannot be
released without using it. Fabricate the cable for forced stop input on the
customer side or purchase our products (sold separately).
(16) When the operation cycle is 0.4[ms], set the system setting as the axis select
switch of servo amplifier "0 to 7".
If the axis select switch of servo amplifier "8 to F" is set, the servo amplifiers are
not recognized.
(17) When the extension base units are used, make sure to configure the modules so
that the total current consumption of the Q170MCPU and individual modules on
the extension base do not exceed the 5VDC output capacity of Q170MCPU
power supply.
(18) The module name displayed by "System monitor" - "Product information list" of
GX Developer is different depending on the function version of Motion modules
(Q172DLX, Q173DPX).
(Note): Even if the function version "C" is displayed, it does not correspond to
the online module change.
Module name
Q172DLX
Q173DPX
Function version "B"
Q172LX
MOTION-UNIT
2 - 7
Model display
Function version "C"
Q172DLX
Q173DPX