Mitsubishi Q170MCPU User Manual page 55

2 SYSTEM CONFIGURATION
Disconnect
Connect
(10Mbps)
Connect
(100Mbps)
(c) Ethernet IP address display mode overview
7-segment LED
(Note): When the Ethernet parameters are not written in the Motion controller, the addresses
are displayed as follows.
• IP address
• Subnet mask pattern
• Default router IP address : 192.168.3.1
(8) PERIPHERAL I/F connector
Transmission
Full duplex
Half duplex
: 192.168.3.39
: 255.255.255.0
Item
Data transmission speed
Communication mode
Transmission method
Cable length [m(ft.)]
2 - 28
Operation overview
(Note)
IP address
(ex. 192.168.3.39)
Subnet mask pattern
(Note)
(ex. 255.255.255.0)
Default router IP
(Note)
address
(ex. 192.168.3.1)
Link status
Specification
100Mbps/10Mbps
Full-duplex/Half-duplex
Base band
Up to 30 (98.43)