Mitsubishi Q170MCPU User Manual page 180

APPENDICES
(b) Connection via HUB
Between the Motion controller and MT Developer2 can be connected via
HUB.
Ethernet cable
(Straight cable)
PERIPHERAL I/F
1) Setting in Motion controller side
Set the items on the Built-in Ethernet Port Setting in Basic Setting as
shown below.
a)
a) Set the Motion controller IP address.
(Default IP address: 192.168.3.39)
Change the IP address if required.
No need to set "Subnet Mask Pattern" and "Default Router IP
Address".
APP - 9
Ethernet cable
(Straight cable)
HUB
MT Developer2
Panel computer
b)