Assembly Of Rear Cover Assy - Brother SL100 Service Manual

Application of
Assembly
2

Assembly of Rear cover assy

1. Set the thread guide assy to the rear cover, and tighten the screw (taptite, cup P M4X20) temporarily.
*Key point
• Fully tighten the screw after performing
2. Set the bobbin presser to the boss of rear cover, and tighten the screw (taptite, pan P (S/P W) 3X12)
temporarily.
*Key point
• Place the bobbin presser with the smaller end facing the rear.
• Fully tighten the screw after performing
3. Attach the spool pin stand to the rear cover.
4. Set the spool pin spring to the positioning groove of rear cover.
5. Insert the spool pin into the positioning hole of the rear cover while pulling the spool pin spring.
Taptite, pan P (S/P W) 3X12
Bobbin presser
Spool pin spring
Boss
Spool pin stand
Positioning hole
Rear cover
Taptite, Cup P M4X20
Taptite, Pan P (S/P W) 3X12
Main frame and Covers
"4 - 25 Bobbin
"4 - 25 Bobbin
Spool pin
3 - 59
winder".
winder".
Positioning groove
Spool pin spring
Thread guide assy
Taptite, cup P M4X20