Brother SL100 Service Manual page 87

Application of
Disassembly
12.Remove the two screws (screw, pan (S/P washer) M3X6), and then pull out the presser bar guide and
the spring (XC4900) from the presser bar sub assy.
13.Slide the presser bar sub assy until the presser bar clamp pin align with the notch part, and turn it to the
direction of the arrow 90 degrees. And pull out the presser bar sub assy from the base holder assy.
14.Release the two hooks to pull out the presser foot lifter from the base holder assy.
Screw, Pan (S/P washer) M3X6
Screw, pan (S/P washer) M3X6
Presser bar guide
Hooks
Bobbin winder, Upper shaft, Needle-Presser module
Spring (XC4900)
Presser bar sub assy
Presser foot lifter
3 - 29
Spring (XC4900)
Presser bar clamp pin
Base holder assy
Shaft
Notch part