Feed Dog Position (Front/Back And Left/Right) - Brother SL100 Service Manual

Adjustment
[Standard]
• At pattern selecting dial [10] (straight stitch/center base line/feed length: maximum), the
minimum clearance between the front of the feed dog and the needle plate should be 0.6 to
1.3 mm.
• The left and right clearance between the feed dog and the needle plate should be the same.
[Adjustment]
1. Remove the presser foot and the presser foot holder.
2. Turn the pattern selecting dial until the [10] is the topmost position.
3. Turn the pulley by hand and move the feed dog to the front position.
4. Remove the two screws of the needle plate assy, and remove the needle plate assy.
5. Loosen the two screws of the feed dog. Set the needle plate assy temporarily, and adjust the position of the
feed dog.
6. Tighten the two screws of the feed dog to secure the feed dog to the feed stand assy.
7. Tighten the two screws of the needle plate assy to secure the needle plate assy to the feed module.
Feed dog

Feed dog position (front/back and left/right)

Pulley
10
Pattern
selecting dial
Screws
with hex wrench 2.5 mm
4 - 18
Screw needle plate
Screws
Needle plate assy
Parallel
0.6 - 1.3 mm
a b a = b
Bolt, Socket M3X5
Feed dog
Needle plate assy