Download  Print this page

Advertisement

Application of
Assembly
9. Tighten the needle clamp screw to the needle block of needle bar assy N.
10.Insert the needle bar assy N into the bottom side hole of base holder assy, the needle bar block of
needle bar crank rod assy and the upper side hole of base holder assy, and tighten the screw (set
screw, socket (FT) M4X4) temporarily.
*Key point
• Fully tighten the screw after performing
Base holder assy
Set Screw, Socket (FT) M4X4
Hex wrench 2.0 mm
11.Set the thread take-up lever to the needle bar crank rod assy, and secure it with the screw (screw, flat
SM3.57-40X7 L).
*Key point
• The screw is reverse threaded.
Thread take-up lever
Bobbin winder, Upper shaft, Needle-Presser module
"4 - 14 Needle bar
Set screw, socket (FT) M4X4
Needle bar crank rod assy
Screw, flat SM3.57-40X7 L
3 - 34
height".
Needle bar block
Needle bar assy N
Needle block
Needle clamp screw

Advertisement

Table of Contents

   Related Manuals for Brother SL100

Comments to this Manuals

Symbols: 0
Latest comments: