Brother SL100 Service Manual page 104

Application of
Assembly
4. Set the shaft supporter to the feed holder, and secure it with the two screws (taptite, pan P (S/P W)
3X12).
5. Set the wahser,thrust, the outer rotary hook assy, the washer, the magnet and the washer to the shaft
supporter, and insert the outer rotary hook shaft into them, and secure them with the screw (set screw,
socket (CP) M4X6).
*Key point
• Set it so that the larger end of the feed cam on the lower shaft A assy facing backward, and set the outer
rotary hook assy with the mark facing frontward.
Outer rotary hook shaft
Outer rotary hook assy
Taptite, pan P (S/P W) 3X12
Shaft supporter
Feed holder
Feed unit
Washer
Magnet
Washer
Feed cam
3 - 46
Taptite, Pan P (S/P W) M3X12
Set Screw, Socket (CP) M4X6
Hex wrench 2.0 mm
Wahser,thrust
Mark
Set screw, socket (CP) M4X6
Outer rotary hook assy