Attachment Of Feed Module - Brother SL100 Service Manual

Basic of Assembly
3

Attachment of Feed module

1. Insert the feed adjuster into the feed adjusting shaft of feed connecting lever assy, and set the pin of the
feed adjusting shaft to the two slits of feed adjuster. And insert the two positioning holes of back side of
feed module into the two tabs of arm bed, and set the feed module to the arm bed, and secure it with
the three screws (screw, pan (S/P washer) M4X10).
2. Attach the spring (XF5134) to the feed adjusting shaft of feed connecting lever assy and the arm bed as
shown in the illustration below.
→
Refer to 3 - 45 Assembly of Feed module.
Tabs
Feed module
Screw, Pan (S/P washer) M4X10
Feed unit / Feed control
Pin
Feed adjusting
shaft
2 - 37
Spring (XF5134)
Spring
(XF5134)
Feed adjuster
Screw, pan
(S/P washer) M4X10
Pin
Feed adjusting
shaft