Config Telnet Maxsessions; Config Telnet Mode; Config Telnet Timeout; Show Forwardingdb Agetime - NETGEAR GSM7324 Reference Manual

config telnet maxsessions

This command specifies the maximum number of telnet sessions that can be established. A value
of 0 indicates that no telnet session can be established. The range is 0 to 5.
Default
Format

config telnet mode

This command regulates new telnet sessions. If sessions are enabled, new telnet sessions can be
established until there are no more sessions available. If sessions are disabled, no new telnet
sessions are established. An established session remains active until the session is ended or an
abnormal network error ends it.
Default
Format

config telnet timeout

This command sets the telnet session timeout value, in minutes. A session is active as long as the
session has been idle for the value set. A value of 0 indicates that a session remains active
indefinitely. the time is a decimal value from 0 to 160.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default
Format

show forwardingdb agetime

This command displays the timeout for address aging. In an IVL system, the [fdbid|all] parameter
is required. In an SVL system, the [fdbid|all] parameter is not used and will be ignored if entered.
Default
Format
Forwarding DB ID
Switching Commands
7000 Series L3 Managed Switch Reference Manual for Software v1.0
5
config telnet maxsessions <0-5>
enable
config telnet mode <enable|disable>
5
config telnet timeout <0-160>
all
show forwardingdb agetime [fdbid|all]
Fdbid (Forwarding database ID) indicates the forwarding data-
base whose aging timeout is to be shown. The all option is used to
display the aging timeouts associated with all forwarding data-
May 30, 2003 Beta Draft
7-23