Config Garp Gvrp Interfacemode; Config Garp Jointimer; Config Garp Leavetimer; Config Garp Leavealltimer - NETGEAR GSM7324 Reference Manual

7000 Series L3 Managed Switch Reference Manual for Software v1.0

config garp gvrp interfacemode

This command enables or disables GVRP (GARP VLAN Registration Protocol) for a specific
port. If GVRP is disabled, Join Time, Leave Time and Leave All Time have no effect.
Default
Format

config garp jointimer

This command sets the GVRP join time per port and per GARP. Join time is the interval between
the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership
for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100
(centiseconds)
Default
Format

config garp leavetimer

This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be
considered a buffer time for another station to assert registration for the same attribute in order to
maintain uninterrupted service.time is 20 to 600 (centiseconds).
Note: This command has an effect only when GVRP is enabled.
Default
Format

config garp leavealltimer

This command sets how frequently Leave All PDUs are generated per port. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in order to
maintain registration. The value applies per port and per GARP participation. The time may range
from 200 to 6000 (centiseconds).
7-40
disable
config garp gvrp interfacemode
<slot.port|all> <enable|disable>
20 centiseconds (0.2 seconds)
config garp jointimer <slot.port/all> <10-
100>
60 centiseconds (0.6 seconds)
config garp leavetimer <slot.port/all> <20-
600>
May 30, 2003 Beta Draft
Switching Commands