7000 Series L3 Managed Switch Reference Manual for Software v1.0
config network webmode
This command enables or disables access to the switch through the Web interface. When access is
enabled, the user can login to the switch from the Web interface. When access is disabled, the user
cannot login to the switch's Web server.
Disabling the Web interface takes effect immediately. All interfaces are effected.
Default
Format
config network javamode
This command specifies whether or not the switch should allow access to the Java applet in the
header frame of the Web interface. When access is enabled, the Java applet can be viewed from the
Web interface. When access is disabled, the user cannot view the Java applet.
Default
Format
config prompt
This command changes the name of the prompt. The length of name may be up to 64 alphanumeric
characters.
Default
Format
show serial
This command displays serial communication settings for the switch.
Format
Serial Port Login Timeout (minutes)
Baud Rate
7-16
enable
config network webmode <
enable
config network javamode <
<model #>
config prompt <system prompt>
show serial
Specifies the time, in minutes, of inactivity on a Serial port
connection, after which the Switch will close the connection. Any
numeric value between 0 and 160 is allowed, the factory default
is 5. A value of 0 disables the timeout.
The default baud rate at which the serial port will try to connect.
This is selected from a pull-down menu. The available values are
1200, 2400, 4800, 9600, 19200, 38400,57600, and 115200 baud.
The factory Default is 9600 baud.
May 30, 2003 Beta Draft
>
enable|disable
>
enable|disable
Switching Commands