Quick Start Up Ip Address - NETGEAR GSM7324 Reference Manual

7000 Series L3 Managed Switch Reference Manual for Software v1.0
Table 6-3. Quick Start up User Account Management
Command
config users passwd <user>
save config
logout

Quick Start up IP Address

To view the network parameters the operator can access the device by the following three
methods.
• Simple Network Management Protocol - SNMP
• Telnet
• Web Browser
Note: Helpful Hint: The user should do a save config after configuring the network parameters so
that the configurations are not lost
Table 6-4. Quick Start up IP Address
Command
show network
6-4
Details
Allows the user to set passwords or change passwords needed to
log in.
A prompt will appear after the command is entered requesting the
users old password. In the absence of an old password leave the
area blank. The operator must press enter to execute the
command.
The system then prompts the user for a new password then a
prompt to confirm the new password. If the new password and the
confirmed password match a message will be displayed
This will save passwords and all other changes to the device.
If you do not save config, all configurations will be lost when a
power cycle is performed on the switch or when the switch is reset
Logs the user out of the switch
Details
Displays the Network Configurations
IP Address - IP Address of the interface
Default IP is 0.0.0.0
Subnet Mask - IP Subnet Mask for the interface
Default is 0.0.0.0
Default Gateway - The default Gateway for this interface
Default value is 0.0.0.0
May 30, 2003 Beta Draft
Quick Startup