NETGEAR GSM7324 Reference Manual page 198

7000 Series L3 Managed Switch Reference Manual for Software v1.0
Mark IP DSCP
Mark IP Precedence
Policing Style
Committed Rate (Kbps)
Committed Burst Size (KB)
Excess Burst Size (KB)
Peak Rate (Kbps)
Peak Burst Size (KB)
Conform Action
Conform DSCP Value
Conform IP Precedence Value
Exceed Action
Exceed DSCP Value
Exceed IP Precedence Value
Non-Conform Action
Non-Conform DSCP Value
9-32
Denotes the mark/re-mark value used as the DSCP for traffic
matching this class. This is not displayed if the config diffserv
policy mark ipdscp command was not specified, or if policing is
in use for the class under this policy.
Denotes the mark/re-mark value used as the IP Precedence for
traffic matching this class. This is not displayed if the config diff-
serv policy mark ipprecedence command was not specified, or if
either mark DSCP or policing is in use for the class under this
policy.
This field denotes the style of policing, if any, used (simple, sin-
gle rate, or two rate).
This field displays the committed rate, used in simple policing,
single-rate policing, and two-rate policing.
This field displays the committed burst size, used in simple polic-
ing, single-rate policing, and two-rate policing.
This field displays the excess burst size, used in single-rate polic-
ing.
This field displays the peak rate, used in two-rate policing.
This field displays the peak burst size, used in two-rate policing.
The current setting for the action taken on a packet considered to
conform to the policing parameters. This is not displayed if polic-
ing is not in use for the class under this policy.
This field shows the DSCP mark value if the conform action is
markdscp.
This field shows the IP Precedence mark value if the conform
action is markprec.
The current setting for the action taken on a packet considered to
exceed to the policing parameters. This is not displayed if polic-
ing not in use for the class under this policy.
This field shows the DSCP mark value if this action is markdscp.
This field shows the IP Precedence mark value if this action is
markprec.
The current setting for the action taken on a packet considered to
not conform to the policing parameters. This is not displayed if
policing not in use for the class under this policy.
This field displays the DSCP mark value if this action is markd-
scp.
May 30, 2003 Beta Draft
CLI Commands: Differentiated Services