Config Spanningtree Cst Port Priority; Config Spanningtree Cst Port Edgeport; Config Spanningtree Mst Create; Config Spanningtree Mst Delete - NETGEAR GSM7324 Reference Manual

7000 Series L3 Managed Switch Reference Manual for Software v1.0

config spanningtree cst port priority

This command sets the Port Priority to a new value for use within the common and internal
spanning tree. The <slot.port> is the desired switch port. The priority <value> is a number in the
range of 0 to 240 in increments of 16.
Default
Format

config spanningtree cst port edgeport

This command specifies if a port is an Edge Port within the common and internal spanning tree.
This will allow the port to transition to Forwarding State without delay. The <slot.port> is the
desired switch port. The edgeport <value> can either be "true" or "false".
Default
Format

config spanningtree mst create

This command adds a multiple spanning tree instance to the switch. The instance <mstid> is a
number within a range of 1 to 4094, that corresponds to the new instance ID to be added. The
maximum number of multiple instances supported by 7000 Series L3 Managed Switch Software is
4.
Format

config spanningtree mst delete

This command removes a multiple spanning tree instance from the switch and reallocates all
VLANs allocated to the deleted instance to the common and internal spanning tree. The instance
<mstid> is a number that corresponds to the desired existing multiple spanning tree instance to be
removed.
Format
7-56
128
config spanningtree cst port priority
<slot.port> <0-240>
false
config spanningtree cst port edgeport
<slot.port> <true/false>
config spanningtree mst create <mstid>
config spanningtree mst delete <mstid>
May 30, 2003 Beta Draft
Switching Commands