Config Spanningtree Configuration Name; Config Spanningtree Configuration Revision; Show Spanningtree Port - NETGEAR GSM7324 Reference Manual

config spanningtree configuration name

This command sets the Configuration Identifier Name for use in identifying the configuration that
this switch is currently using. The <name> is a string of at most 32 characters.
Default
Format

config spanningtree configuration revision

This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The <revision> is a number in the range of 0 to
65535.
Default
Format

show spanningtree port

This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The <slot.port> is the desired switch port.
Format
Port mode
Port Up Time Since
Counters Last Cleared
STP BPDUs Transmitted
STP BPDUs Received
RST BPDUs Transmitted
RST BPDUs Received
MSTP BPDUs Transmitted
MSTP BPDUs Received
Switching Commands
7000 Series L3 Managed Switch Reference Manual for Software v1.0
The base MAC address displayed using hexadecimal notation as
specified in IEEE 802 standard.
config spanningtree configuration name
<name>
0
config spanningtree configuration revision
<0-65535>
show spanningtree port <slot.port>
Enabled or disabled.
Time since port was reset, displayed in days, hours, minutes, and
seconds.
Spanning Tree Protocol Bridge Protocol Data Units sent
Spanning Tree Protocol Bridge Protocol Data Units received.
Rapid Spanning Tree Protocol Bridge Protocol Data Units sent
Rapid Spanning Tree Protocol Bridge Protocol Data Units
received.
Multiple Spanning Tree Protocol Bridge Protocol Data Units sent
Multiple Spanning Tree Protocol Bridge Protocol Data Units
received.
May 30, 2003 Beta Draft
7-51