Outbound Telnet - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch Software Administration Manual

ProSafe 7000 Managed Switch Software Administration Manual, Release 8.0.3
b. Under Dual Image Configuration, scroll down to image 2, select the checkbox for that image. The
image2 now appears in the Image name field at the top.
c. Select TRUE in the Active Image field.
d. Click Apply.

Outbound Telnet

In this section, the following examples are provided:
• "CLI: show network" on page 15-11
• "CLI: transport output telnet" on page 15-12
• "CLI: session-limit and session-timeout" on page 15-13
Outbound Telnet:
• Establishes an outbound telnet connection between a device and a remote host
• A telnet connection is initiated, each side of the connection is assumed to originate and terminate at a
"Network Virtual Terminal" (NVT)
• Server and user hosts do not maintain information about the characteristics of each other's terminals and
terminal handling conventions
• Must use a valid IP address
CLI: show network
(Netgear Switch Routing) >telnet 192.168.77.151
Trying 192.168.77.151...
(Netgear Switch Routing)
User:admin
Password:
(Netgear Switch Routing)
Password:
(Netgear Switch Routing)
IP Address............................... 192.168.77.151
Subnet Mask.............................. 255.255.255.0
Default Gateway.......................... 192.168.77.127
Burned In MAC Address.................... 00:10:18.82.04:E9
Locally Administered MAC Address......... 00:00:00:00:00:00
MAC Address Type......................... Burned In
Network Configuration Protocol Current... DHCP
Management VLAN ID....................... 1
Web Mode................................. Enable
Java Mode ............................... Disable
15-11
>en
#show network
v1.0, June 2010
Tools