7000 Series L3 Managed Switch Reference Manual for Software v1.0
Format
transfer upload mode
This command specifies whether XMODEM or TFTP mode is used when uploading from the
switch.
Default
Format
transfer upload serverip
This command sets the IP address of the server on which the file is located.
Note: This command is valid only when the transfer mode is TFTP. See "transfer upload mode" .
Default
Format
transfer upload path
This command sets the directory path used to upload the file. The switch "remembers" the last file
path used.
Note: This command is valid only when the transfer mode is TFTP. See "transfer upload mode" .
7000 Series L3 Managed Switch Software supports TFTP client. The TFTP client path statement
requirement is sever dependent. A path statement is generally required to setup the TFTP client;
however, the client path may remain blank.
See the example of the path setup.
TFTP Upload Example:
7-64
logout
xmodem. This is valid only when the transfer is initiated by the
serial EIA 232 port.
transfer upload mode <xmodem|tftp>
0.0.0.0
transfer upload serverip <ipaddr>
The TFTP upload example details three scenarios for TFTP client to server file
transfer.
In the example, the operator will upload the config.bin file from the switch to the
location c:\tftp\ on the server. The different scenarios are detailed below:
May 30, 2003 Beta Draft
Switching Commands